Step 1: Find a Buddy

Grab a buddy—someone you trust with a steady hand and your precious windshield. Two hands are good, but four hands? Banner-applying perfection! Plus, having someone to blame if things go wrong is priceless.

Step 2: Prepare the Area

1. Begin by thoroughly cleaning the windshield area where the banner will be applied. Use rubbing alcohol for best results, as window cleaner may leave a residue. Watch out for dust particles after cleaning.
2. Measure and align the banner to your desired position. Secure it with masking tape to hold it in place.

Step 3: Peel and Secure the Sun Strip

1. Use masking tape to secure one half of the banner.
2. Have another person hold up the unsecured side of the banner, then carefully peel off the white backing paper.
3. Use a sharp razor to cut the backing paper in the middle, leaving one half of the adhesive exposed.

Step 4: Apply the Banner

1. Using a squeegee or a credit card, press the exposed half of the banner onto the windshield, starting from the center and moving outward. This technique helps avoid air bubbles.
2. The person holding the banner should maintain slight tension to prevent wrinkles and bubbles.
3. Repeat this process for the other half of the banner, following the same method.

Step 5: Trim and Finalize

1. Carefully use a sharp razor to trim any excess vinyl, avoiding contact with the windshield gasket.
2. Slowly peel off the transfer tape at a shallow angle to prevent lifting the banner off the surface.
3. For enhanced adhesion, use a hairdryer to gently heat the edges of the banner.

Congratulations, your Scrapelevel banner is now applied!